How to Jump a Motherboard? Steps Guideline

Jump-starting a motherboard means turning on the motherboard without using the power switch of your PC. It’s such a great technique as you can turn your PC on if you face an issue with your computer’s power switch.

Also, sometimes, people use to do it to do the benchmark test of a new motherboard without installing the mobo into the case. The jumpstart process is very handy and can be done quite easily. Just you will need to short two pins of your motherboard to get your job done!

If you are willing to do so then this article can guide you properly. So, stay with us till the end and find out how to jump a motherboard. Welcome, onboard Capitan! Let’s sail the ship to the land of the unknown! 

Equipment Requirement for Jump-start a Motherboard

To jump-start a motherboard, you will need a couple of things. These things will make the work easier and you can do it smoothly. Here are the things you will need –

• An anti-static band – This type of band helps to keep the sensitive electrical components of your mobo if there are any unintentional discharges of static electricity. 

• A needle-nose plier, Screwdriver, or jumper cap – with any of these tools, you will need to short a pair of pins of your mobo.

These two are important things when you opt to jump-start a motherboard. So, make sure you have them with you before starting the process. Now, let’s bring life to your motherboard!

Steps for Jump-start a Motherboard

You will need to follow a few simple steps to jump-start your motherboard. Make sure you have put on the anti-static band and connect the crocodile clip to a grounded piece of metal. Turn the system off, remove the power sources, and open up the case. Now, let’s begin the process –

Step 1: Power Up the Motherboard

If you are using a new motherboard then you will need to connect it to the power supply and power on the board. Connect the 24-pin power connector to the motherboard power port. However, if you are using an old mobo then you will connect the 20-pin power connector. 

Step 2: Find Out the Power Button and Ground Pins on Your MOBO

First of all, we will need to find out a pair of pins on your motherboard which are known as POWER BUTTON and GROUND pins. At the bottom of the motherboard, you will find a set of pins, and there you will find these two pins situated next to each other. 

If you can’t find it, then you will need to inspect the mobo closely and look for PWRBTN# and GND. These two pins are also known as power switch connectors and they are used to turn on the computer.

Step 3: Short the Pins 

After completing the two steps, we are in the end game. Now, it’s time to perform the THANOS snap to jump-start your motherboard. Take a plier or screwdriver, and bridge the PWRBTN# and GND (Ground) pins, hold the screwdriver until the CPU fan starts spinning.

Once the motherboard is turned on, remove the screwdriver from the top of the pins. 

People Also Ask – PAA

Is there are any on-board power buttons on a motherboard?

Yes, modern motherboards come with a dedicated power button on them. If you own a modern high-end motherboard, then you will find a round or square button that is used for turning on the motherboard. You won’t need to jump-start such kind of mobos. 

Is it safe to jump a motherboard?

Yes, it’s absolutely safe till you are doing it consciously. You will need to touch the exact two power pins and wearing the anti-static band is a must. Do the work properly and there won’t be any consequences.

Final Thoughts

Well, performing jump-start isn’t that hard, is it? Just need to take a few precautions into consideration and follow the steps properly, and then you will be able to bring life to your MOBO! So, follow the aforementioned steps properly and if you face any issues while doing so, don’t hesitate to reach us through the comment box below.