Flip Slide HD Won’t Turn On | How to Fix
If you own the camera but unfortunately your Flip SlideHD won’t turn on all of a sudden, then you should go for some troubleshooting.
Therefore, you may need to reset the camera. Check if the batteries aren’t dead before proceeding. You can reset your Flip camera by taking out and re-inserting the rechargeable battery after making sure the batteries are charged sufficiently.
If that doesn’t solve the problem for you, all Flip cameras have a small button on the bottom that will restore your camera to its factory default settings. To reset the device, hold the reset button for at least ten seconds.
Read the article till the end to know how to fix this issue along with its causes in detail.
Why My Flip Slide HD Won’t Turn On?
There’re several possible causes that can be culprits of this inactivity issue. Here’re them –
1. Defective Logic Board
If your Flip SlideHD can’t just turn on, the logic board is probably to blame and needs to be changed.
2. Defective Display
It’s conceivable that nothing displays on the display because the quality and condition of the display are poor. If other important parts of your device are working well but the camera still won’t turn on, it’s conceivable that the display has to be replaced because it may be defective or severely damaged.
3. Defective Battery
It’s quite possible that the battery may just be dead and has to be recharged by connecting the camera to a power outlet using the charger. If it has been charged but still won’t turn on, it’s assumable that the battery is faulty and it might need a new battery.
A Step-by-Step Solution for ‘Flip Slide HD Won’t Turn On Issue’
Now you’ll know about the efficient methods that you can use to solve this annoying problem. Follow these steps to get rid of it successfully –
Step 1: Check the charge of your batteries. On the side of the camera, you’ll find a USB charging connector.
On your PC, connect it to a powered USB port. Retry to turn on the camera after letting the device stay connected for the batteries to finish charging. It probably requires at least three hours.
Reset the battery if the problem still remains.
Step 2: By opening the battery clip and sliding down the device’s front panel, you may access the battery compartment. Replace the batteries after removing them from the device and waiting for a minute.
Step 3: Go for a hard reset. In order to do so, use a safety pin, or any other similar pointed object and apply it in the reset hole found within the tripod mount of the camera.
Keep in mind that you should avoid inserting a toothpick or other delicate object as it can be stuck in the hole by breaking off.
The pin should be pushed and held as deep as it will go in the hole. Remove the object when at least five seconds have passed.
Step 4: For at least five seconds, press and hold down the Power button located on the camera. Release the button when five seconds pass to power up the camera.
Conclusion
So far, we’ve shared all the necessary information regarding Flip SlideHD won’t turn on including possible causes and solutions. We hope that this article will help you to be safe from this problem. Don’t hesitate to share your opinion with us.
