[Fixed] Onkyo Receiver Won’t Turn on Clicks (100% Working)

Yes, this will be not a good sign if the Onkyo receiver won’t turn on clicks. But, you would not need to be worried if you have faced the error. Because the error is solvable. 

By the way, you have come to the right place though it’s tough to find the in-depth guidelines to get rid of the error. After exploring this entire article, hopefully, you can solve the issue.

Let’s explore.

Why Onkyo Receiver Won’t Turn on Clicks?

There might be two possible things that cause the error. 

• It might be an electrical problem. Your receiver might have a grounding problem here. That’s why the error may occur.
• On the other hand, the speaker wire connections may be misguided by touching each other. This can be another reason for occurring the error.

How to Fix ‘Onkyo Receiver Won’t Turn on Clicks’ the Receiver Error

Whatever the reasons are, the error is solvable. You can solve it by applying some DIY. I will describe all the possible fixes below. Before that, let’s have a check the list first. 

• Fix 1: Unplug the Receiver
• Fix 2: Try Different Connection
• Fix 3: Replacing AMP Transistor
• Fix 4: Repairing 

Fix 1: Unplug the Receiver

When you face the error, you have to just isolate the receiver from the power outlet for a minimum of 15 seconds by simply unplugging it. 

This will be a first-hand try. If you still face the error, you will need to follow the below fixes. 

Fix 2: Try Different Connection

Again unplug the receiver and plug it into the alternate connection of the speaker. Then check the existence of the error. 

In some cases, it will help you, but on the other hand, the problem may still remain. If so, you need to resolve some technical issues. 

Fix 3: Replacing AMP Transistor

To resolve the issue, you may need to replace the Pre AMP transistor or the Power AMP transistor. So, check the transistor and replace them with which one it needs. 

Additionally, I would like to inform you that Pre AMP is relatively cheap but Power AMP is a slight bit expensive. 

After replacing the AMP transistor, you would check the error. If somehow, you still face it, you need to follow the last fix.

Fix 4: Repairing

When no other DIY helps you to get rid of the error, you need to think differently and try some alternate way. The problem may remain in the output section, instead of the input section. 

So, first, you have to disconnect the speaker wire and check the receiver’s response. If you get the response, you will need to change the speaker wire. 

On the other hand, if you do not get any response, you will need to take the Onkyo receiver to the technician. So, when you need to do this, I would like to recommend you to check the warranty of your receiver. 

Frequently Asked Questions (FAQs)

Why does my receiver make a clicking noise?

Most of cases, the Onkyo receiver makes a clicking noise because of the solder joint. It can also happen for a faulty relay. 

How do I get my Onkyo receiver out of standby mode?

You can do it by simply turning the volume to the maximum setting and keeping the receiver on for at least 30 seconds.  

Is there a fuse in the Onkyo receiver?

Yes, the receiver has a fuse. You can find a single to multiple fuses in a different part of the different receiver. 

Final Words

In the end, I hope that you would get rid of the error- Onkyo receiver won’t turn on clicks. I would like to concern you to do not mess up the fix application.